1200 ampere??
Holder dom pall for FM Acoustics FM111 med 1200 Ampeere
i pulser... ?
De her er og små. ca 7kg med atombombe...
SPECIFICATIONS
Minimum Power Output:
230 W peak into 8 Ohms
360 W peak into 4 Ohms
500 W peak into 2 Ohms
115 W RMS into 8 Ohms
180 W RMS into 4 Ohms
250 W RMS into 2 Ohms
Max. Output Voltage: 100 V pp.
Max. Output Current:
Unlimited repetitive peak output current.
More than 20 A continuous per channel.
No output or DC fuses, absolutely no form of current-, voltage- or any other kind of limiting.
Distortion: Average distortion: 0,005% THD
Bandwidth including Input Filter:
Less than 1 Hz to 60 kHz;
if required, internally settable to any frequency between 1 kHz and 60 kHz (Low-Pass) and
1 Hz to 1 kHz (High-Pass).
Risetime at Full Power: 3 us
Hum and Noise:
Below full power typically better than -110dB
Minimal unweighted:
better than -100 dB (20Hz-20kHz).
Input:
Proprietary electronically balanced discrete enhanced class A circuitry, non-polarized, floating ground, non- inverting or inverting mode. Optimal performance with either balanced or unbalanced (single-ended) sources. Unbalanced sources are automatically balanced right at the input of the FM 111.
Input Sensitivity:
1,2 V RMS for full output
Input Impedance:
At all level settings from balanced and unbalanced sources: 40 kOhms
Input Stage Common Mode Rejection:
90 dB typically, better than 80 dB at 50 Hz, even better at other frequencies.
Load Impedance:
No minimum impedance. The amplifier is designed for 1 Ohm to 10'000 Ohm systems. It can drive any speaker impedance (even below 1 Ohm) with dynamic (music) signals without any limiting, compression or other negative effects on the audio signal. Despite this, the amplifier is fully protected against short circuits, open circuits and all other adverse conditions via a unique onboard computer that continuously surveys all important parameters.
--------------------------------------------------------------------------------
© 2003 FM ACOUSTICS LTD. Last update of this site April 28, 2003
